If you haven’t seen it yet Prusa’s i3 Mk3 MMU 2.0 printer module offers up multi-material printing using five pre-loaded filaments with a single extruder. The magic happens with a fairly ingenious filament selector module hanging out above the printer proper. And it works. The selector is adequate at selecting filaments and I’m not seeing … Continue reading Prusa i3 Mk3 MMU 2.0 Banging on Start
My Prusa i3 Mk3 printer’s LM8UU bearings were acting up. It could’ve been an issue with the installation. Or they might’ve just been junk out of the box. Regardless, it’s time to replace them.
With three Igus Drylin bushings in-hand I’ve decided to swap those in on the printer, at least temporarily.
Building your own box fan filter is a great way to reduce the amount of dust in your workspace. I’m going a step further and adding in a variable speed motor control!
3 months ago I set out to buy the cheapest PLA filament on EBay and see if it was total garbage. And I’ve now printed off about two thirds of the spool. What’s do the prints look like after printing out a pound and a half of plastic?
Counting the IGUS Drylin bushing test as a success I’m moving back to bearings. For now. Here’s why.