Linux to 3D Printing and Back Again
Are you sanding down 3D prints? Metal bar-stock or tubes? Wood? A DIY Sanding pad could make a great addition to your toolchest! When the surface you’re sanding is flat a hand sander or stick with sandpaper tacked in works just fine. But for situations where you’ll be working a rounded surface something more pliable…
WowStick’s 1F Plus is, on the face of it, a decent low-torque power screwdriver. From the spec sheet it appears to be limited to low, non-plastic destroying torque on drive and a bit higher torque on reverse.
I was attempting use a Craftsman bench press to center drill Titanium bolts with HSS drill bits. It didn’t go well so I’ve made a tool to square the table.